Command Protocol Reference Guide
A - 43
Telephony Parameters
Telephony Parameter Summary
Some telephony API commands operate on the input virtual channel and
some operate on the output virtual channel. Below is a table of commands and
whether they operate on the input or output channel.
set matrix_pan "Phone In"
"Amplifier" -1
val matrix_pan "Phone In"
"Amplifier" -1.000
Sends the mono virtual channel "Phone In" to only the left
channel of the stereo virtual channel "Amplifier".
set matrix_pan "Phone In"
"Amplifier" 0
val matrix_pan "Phone In"
"Amplifier" 0.000
Sends the mono virtual channel "Phone In" to both the
left and right channels of the stereo virtual channel
"Amplifier".
set matrix_pan "Table Mic
1" "HDX Stereo Mics Out"
-1
val matrix_pan "Table Mic
1" "HDX Stereo Mics Out"
-1.000
Sends the mono virtual channel "Table Mic 1" to the left
channel of the stereo virtual channel "HDX Stereo Mics
Out".
Command Input channel Output channel
phone_auto_answer_en
✔
phone_connect
✔
phone_dial
✔
phone_dial_tone_gain
✔
phone_dtmf_gain
✔
phone_entry_tone_en
✔
phone_exit_tone_en
✔
phone_flash
✔
phone_flash_delay
✔
phone_redial
✔
phone_ring
✔
phone_ring_tone_en
✔
phone_tone_gain
✔
To Next Page
Loading...
