respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
T01GAINIT10
Set gain on
input T to 10
dB.
T01GAINIT10
T01GAINIT?
Query the
gain on input
T .
F01GAINI2xB01GAINITxS01GAINIAxQ01GAINIAxT01GAINITx,
where x is a number between 0 and 30, depending on the current
setting of the gain on input channel T .
T01GAINI*6
Set gain on
all inputs (T)
to 6 dB.
T01GAINI*è
T01GAINI*?
Query gain
on all inputs
(T).
T01GAINI*x, where x is between ä and ÿ, depending on the current
setting of the gain for the input channel.
8.33. GAINO -- Set Output Gain
This command sets or queries the gain (in dB) of the output channels (only T on the EF2201).
This command is a channel integer command. See
Section 6.3 and Section 6.2 for more information on
this type of command. The minimum and maximum values for this command are -100 and 20,
respectively.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
T01GAINOT10
Set gain on output channel T to 10 dB.
T01GAINOT10
T01GAINOT?
Query the gain on output channel T.
, , T01GAINOTx where x is a number
between -100 and 20, depending on the
current setting of the gain on output channel
T.
T01GAINO*6
Set the gain on all output channels
(only T on the EF2201) to 6 dB.
T01GAINO*è
T01GAINO*?
Query gain settings on all output
channels (only T on the EF2201).
T01GAINO*x, where x is between <space>
and ÿ, depending on the current setting of
the gains for each of the output channel T.
8.34. GAINP -- Set Phone Output Gain
To Next Page
Loading...
