Polycom Vortex EF2201 - MUTEO - Mute One or More Outputs

Example Description Status Message
T01MUTEIT1
Mute input T.
T01MUTEIT1
T01MUTEIT0
Unmute input T.
T01MUTEIT0
T01MUTEIT2
Toggle mute status of input T .
T01MUTEITx, where x is either 0 or 1
depending on the current mute status of the
input.
T01MUTEIT?
Query mute status of input T.
T01MUTEITx, where x is either 0 or 1
depending on the current mute status of the
input.
T01MUTEI*1
Mute all inputs (only T on the EF2201).
T01MUTEI*1
T01MUTEI*0
Unmute all inputs (only T on the
EF2201).
T01MUTEI*0
T01MUTEI*?
Query mute status of all inputs.
T01MUTEI*x where x is either 0 or 1
depending of the current status of the mute
on the corresponding input. If this command
was sent after the example above, then the
status message would be T01MUTEI*0.
8.72. MUTEO -- Mute One or More Outputs
This command sets or queries the mute status of the analog outputs (only T on the EF2201).
This command is a channel boolean command. See
Section 6.3 and Section 6.1 for more information on
this type of command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
T01MUTEOT1
Mute output T.
T01MUTEOT1
T01MUTEOT0
Unmute output T.
T01MUTEOT0
T01MUTEOT2
T01MUTEOTx, where x is either 0 or 1
depending on the current mute status of the
output.
T01MUTEOT?
Query mute status of output T.
T01MUTEOTx, where x is either 0 or 1
depending on the current mute status of the
output.
T01MUTEO*1
Mute all outputs (only T on the EF2201).
T01MUTEO*1
T01MUTEO*0
Unmute all outputs (only T on the
EF2201).
T01MUTEO*0