Polycom Vortex EF2201 - MINI - Enable Modem Initialization String

T01MGAINWB0,WM0,-3
Set crosspoint gain in EF
Bus submatrix on
crosspoint that routes the
W bus signal from the
device at ID0 (WB0) to W
submatrix output 0 (WM0).
T01MGAINWB0,WM0,-3
T01MGAINT,*,èÇ
Set all crosspoint gains for
input channel T. Set the
gain to the telephone
output to 6 dB (è), and the
gain to the P bus output to
-3 dB (Ç).
T01MGAINT,*,èÇ
T01MGAINT,*,-3
Set all crosspoint gains for
input channel T to -3 dB.
T01MGAINT,*,ÇÇ
T01MGAINT,*,>12
Increase the gain for all
crosspoints of input
channel T by 12 dB.
T01MGAINT,*,ab, where the value of each of
letters (a, b, etc.) depends on the current state
of each of the crosspoint gains. If this command
was issued after the example above, then the
status message would be T01MGAINT,*,èè
T01MGAINT,*,?
Query the gains for all
crosspoints of input
channel T.
T01MGAINT,*,ab, where the value of each of
letters (a, b, etc.) depends on the current state
of each of the crosspoint gains. If this command
was issued after the example above, then the
status message would be T01MGAINT,*,èè
8.68. MINI -- Enable Modem Initialization String
This command controls whether or not the modem initialization string is sent at power-up. If MINI is 0,
then the modem initialization string is not sent. If MINI is 1, then the modem initialization string is
sent. The text of the modem initialization string is set via the
MINISTR command.
This command is a boolean command. See
Section 6.1 for more information on this type of command.
This command is saved to global non-volatile memory and is not part of a preset. Its value is saved
each time it is changed. It will retain its value after power-down. Since this command writes to non-
volatile memory, there will be a delay before an acknowledgment is returned.
Example Description Status Message
T01MINI1
Enable modem initialization string.
T01MINI1
T01MINI0
Disable modem initialization string.
T01MINI0
T01MINI2
Toggle enabled state of modem initialization
string.
T01MINIx, where x is 0 or 1 depending
on the current enabled state of the
modem initialization string.