T01PEQIAT,2,1,1250,40,-20,1,1
Set the
parametric EQ on
input , band 2 to
the following
parameters: type
= parametric
filter, frequency
= 1250 Hz,
bandwidth = 40
1/100th octaves,
gain = -20 dB,
enabled = yes,
slope = 1 dB per
octave. The value
of the slope
parameter is
irrelevant for this
type of filter, we
could have set it
to anything.
T01PEQIAT,2,1,1250,40,-20,1,1
T01PEQIAT,1,?
Query the current
parameter
settings for the
parametric eq
filter on input T,
band 1.
T01PEQIAT,1,t,f,b,g,s,e, where the
parameters t, f, b, g, s, and e correspond
to the current settings of the type,
frequency, bandwidth, gain, slope, and
enabled parameters, respectively. If this
filter was set to the same parameters as
given in the above example, the status
message would be
T01PEQIAT,2,1,1250,40,-20,1,1.
8.79. PEQIB -- Set Bandwidth Parameter for Specified
Parametric EQ Input Stage
This command sets or queries the bandwidth parameter (in 1/100th octaves) for the parametric
equalizer (EQ) filters on input channel T. Each channel has five bands of parametric EQ that can be
independently controlled.
The minimum and maximum values for the bandwidth parameter are 5 and 200, respectively.
This command has the same format and restrictions as the
PEQIA command except that only one
parameter, the bandwidth, is specified instead of all the parameters. See the
PEQIA command for more
information. To set the bandwidth parameter for an output parametric EQ filter, use the
PEQOB
command. To set all the parameters for an output parametric EQ filter, use the
PEQOA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
To Next Page
Loading...
