Polycom Vortex EF2201 - PEQOE - Set Enabled Parameter for Specified Parametric EQ Output Stage; PEQOF - Set Frequency Parameter for Specified Parametric EQ Output Stage

Example Description Status Message
T01PEQOBT,2,40
Set bandwidth of parametric EQ
on output T, band 2 to 40
1/100th octaves.
T01PEQOBT,2,40
T01PEQOBT,1,?
Query current bandwidth setting
of parametric EQ on output T,
band 1.
T01PEQOBT,1,b, where b is the current setting
of the bandwidth parameter for the parametric
EQ on output T, band 1. If the bandwidth
parameter of this filter is set to the same value
given in the example above, then the status
message will be T01PEQOBT,1,40.
8.87. PEQOE -- Set Enabled Parameter for Specified
Parametric EQ Output Stage
This command sets or queries the enabled parameter (0 = filter is disabled, 1 = filter is enabled) for
the parametric equalizer (EQ) filters on output channel T. Each channel has five bands of parametric EQ
that can be independently controlled.
This command has the same format and restrictions as the
PEQOA command except that only one
parameter, the enabled status, is specified instead of all the parameters. See the
PEQOA command for
more information. To set the enabled parameter for an input parametric EQ filter, use the
PEQIE
command. To set all the parameters for an intput parametric EQ filter, use the
PEQIA command.
This command is saved to non-volatile memory only as part of a preset. The state of this command will
be restored after power-up only if a preset is saved and that preset is set to be the power-on preset.
Example Description Status Message
T01PEQOET,2,1
Enable parametric EQ on output
T, band 2.
T01PEQOET,2,1
T01PEQOET,1,?
Query enabled status of
parametric EQ on output T, band
1.
T01PEQOET,1,e, where e is the current
setting of the enabled parameter for the
parametric EQ on output T, band 1. If the
enabled parameter of this filter is set to the
same value given in the example above, then
the status message will be T01PEQOET,1,1.
8.88. PEQOF -- Set Frequency Parameter for Specified
Parametric EQ Output Stage
This command sets or queries the frequency parameter (in Hz) for the parametric equalizer (EQ) filters
on output channel T. Each channel has five bands of parametric EQ that can be independently
controlled.
The minimum and maximum values for the frequency parameter are 20 and 20000, respectively.