Polycom VSX 3000

Troubleshooting
12 - 15
Cannot display content on
the main monitor.
The system was changed
from using a PAL/NTSC
main monitor and a VGA
secondary monitor to using
a single PAL/NTSC monitor
and no second monitor.
Set content for VGA Out and then set content for
Monitor 1.
Call participants cannot see
or hear what is being
played on the VCR or DVD.
The VCR or DVD is not
selected.
Select the VCR (Camera 3):
Press
Camera, then press 3.
The VCR or DVD is not set
up correctly.
Check that the VCR or DVD is connected according
to the instructions in the section Connecting
VCR/DVD on page 5-1.
Refer to the manufacturer’s instructions to set up the
VCR or DVD correctly.
Picture freezes frequently
or becomes blocky during
an IP call.
There is too much traffic on
the LAN. Check the error
count on the Call Statistics
screen.
Go to Admin Settings > Network > IP > Quality of
Service and enable dynamic bandwidth.
The network is
experiencing packet loss.
Go to Admin Settings > Network > IP > Quality of
Service and specify a smaller value for Maximum
Transmission Unit Size.
Picture freezes frequently
during an ISDN call.
Too many network line
transmission errors. Check
the error count on the
Diagnostics > Call
Statistics screen to verify
this.
Try the call again.
Network interface cable or
cables may be bad.
Replace the cable or cables.
Picture is slow or jerky. The system is receiving
video that includes a large
amount of motion.
A background with less motion provides a better,
smoother video picture.
Too many network line
transmission errors. Check
the error count on the
Diagnostics > Call
Statistics screen to verify
this.
Try the call again, possibly at a lower network speed.
Only one 64 kbps channel
is connecting in your call.
Check the ISDN number of the far site. Ask the far
site to call your site.
The video image appears to
be tilted.
VSX 5000: The camera is
not pointed correctly.
Check that the camera is pointed perpendicular to
the subject.
Symptom Problem Corrective action