Polycom VSX 3000

Monitors and Cameras
3 - 5
4. Select and configure these settings:
Visual
Concert VGA
Out
VSX 5000
VSX 6000
VSX 6000A
VSX 7000
VSX 7000s
Specifies whether to show content on the Visual Concert™ VSX
display.
VGA Out
VSX 7000e
VSX 8000
Specifies whether to show content on the display connected to
the system’s VGA output.
VCR Record
Source
VSX 7000s
VSX 7000e
VSX 8000
Specifies the video source to be recorded to videotape or DVD.
If Far is enabled, the recorded video will switch to the current far
site speaker. If both Near and Far are enabled, the recorded
video will switch between near and far sites depending on the
current speaker. This selection is available only when you are
using a single monitor.
Setting Description
Setting Description
VCR
VSX 7000s
VSX 7000e
VSX 8000
Specifies the VCR/DVD Player output format:
•S-Video — Select if you have a VCR or DVD player
connected to the system’s S-Video output using an S-Video
cable.
• Composite — Select if you have a VCR or DVD player
connected to the system output using a composite video
cable.
PIP Specifies PIP (Picture-in-Picture) behavior:
•Camera — The PIP window is displayed when the call is first
connected and when a user moves the camera, uses presets,
or switches to a different camera source.
•On — The PIP window stays on for the duration of the call.
• Off — The PIP window is not displayed during the call.
•Auto — The PIP window is displayed when a user picks up
the remote.
Note: PIP settings are also available in the User Settings screen.
Users can turn the PIP on or off and change its location on the
screen using
PIP on the remote control.