Powtran pi130 series User Manual

Chapter 1 Inspection and Safety Precautions
3
Process
Type
Explanation
do not incorrectly connect wires! Otherwise which may
cause damage to the driver!
★ Ensure that the distribution line meets the regional safety
standards of EMC requirements. The diameter of used
wire shall refer to the recommendations of this manual.
Otherwise it may cause an accident!
★ When connecting to braking resistor,the braking resistor
must be connected to position between terminals (P, RB) of
the inverter
Before
energizing
Note
★ Please confirm whether the input power voltage is same
as the inverter rated voltage; wiring positions of power
input terminals (R,S,T) and output terminals (U,V,W) are
correct or not; and note that if there is a short circuit in the
peripheral circuit connected to driver,if the connected
lines are tight, otherwise it may cause damage to the
driver!
★ Do not need to perform withstand voltage test for any
part of the inverter,this product has been tested before
leaving factory. Otherwise it may cause an accident!
Danger
★ The inverter's cover plate must close before power on.
Otherwise it may cause an electric shock!
★ Wiring of all external accessories must comply with the
guidance of this manual,please correctly wiring in
accordance with the circuit connection methods described
in this manual. Otherwise it may cause an accident!
After
energizing
Danger
★ Do not open cover plate after energizing. Otherwise
there is a risk of electric shock!
★ Do not touch the driver and peripheral circuits with wet
hands. Otherwise there is a risk of electric shock!
★ Do not touch any input and output terminals of the
inverter. Otherwise there is a risk of electric shock!
★ The inverter automatically perform the safety testing for
the external strong electrical circuit in the early stages of
energizing, therefore never touch the driver terminals (U,
V, W) or motor terminals, otherwise there is a risk of
electric shock!
★ If you need to identify the parameters, please pay
attention to the danger of injury during motor rotation.
Otherwise it may cause an accident!
★ Please do not change the inverter manufacturer
parameters. Otherwise it may cause damage to this unit!
During
operation
Danger
★ Do not touch the cooling fan and the discharge resistor
to feel the temperature. Otherwise it may cause burns!
★ Non-professional personnel is not allowed to detect
signal when operating. Doing so may cause personal

Powtran pi130 series Specifications

General

Brand	Powtran
Model	pi130 series
Category	Inverter
Language	English