Chapter 5 Function parameter
90
12: Inverter overload (E.oL2)
16: Inverter module overheating
fault (E.oH2)
17: External fault (E.SET)
18: Communication fault
(E.CE)
19: Current detection fault
(E.oCC)
20: Auto tuning fault (E.tE)
21: EEPROM operation fault
(E.EEP)
22: PID feedback disconnection
fault (E.PId)
Record the type of the last three faults of inverter, see the troubleshooting for the
details.
Running frequency of
current fault
Output current of
current fault
Bus voltage of current
fault
Input terminal status of
current fault
Output terminal status
of current fault
The status of current fault input terminal are decimal digits. Display all digital input
terminal status of the last fault, the order is:
When the input terminal is ON, the corresponding bit is 1, OFF for 0. This value can be
used to understand the state of digital input signal at the sate of failure.
The status of current fault output terminal are decimal digits. Display all digital output
terminal status of the last fault, the order is:
When the output terminal is ON, the corresponding bit is 1, OFF for 0. This value can
be used to understand the state of digital output signal at the sate of failure.
To Next Page
Loading...
Need help?
General
