■ 5 Working with the configuration menu
30
5 Working with the
configuration menu
This chapter describes the configuration menu and its functions.
To activate the menu, see Chapter 4.5 “Activating the two main me-
nus” and Chapter 4.6 “How the menu control operates”.
5.1 Structure of the configuration menu
The basic adjustment of the balance is defined in the configuration
menu:
Printing conventions used in this document:
• The settings in the sub-paths pre-programmed in the works are prin-
ted in bold in these operating instructions.
Main path Definable functions
LANGUAGE
Language (E, G, F)
UNIT-1
Unit in which the results of the weighing are dis-
played
SET
DATA PRINT
Print formats; Type of values to be printed (indivi-
dual values, continuous printout, time or load
change dependent values, date, time, user, etc.)
SET
CALIBRATION
Method of calibration
SET
WEIGHING MODE
Stability mode (Quality of the balance location),
Auto-Standby mode, zero correction, tare method
(rapid or standard tare)
SET
INTERFACE
Baud-rate, parity, handshake functions of the peri-
pheral interface
SET
DATE AND TIME
Date and time (standard format or American for-
mat p.m. and a.m.)
PASSWORD
Password protection for defining the menus
THEFTCODE
Activating/deactivating and changing the anti-theft
code.
KEY TONE
Activation of the keypad sound
BUS
Enables disables Precisa BUS accessories
To Next Page
Loading...
