7 Special operating keys ■
51
7.2 The Print key «PRINT»
• Print out an individual value or a report
– Ensure that the balance is in the weighing mode
–Briefly press «PRINT»
– The individual value or report will be printed out.
• Reset product counter to 1
– Ensure that the balance is in the weighing mode
– Keep «PRINT» pressed until “RESET PROD.-COUNTER” is
displayed
– Release «PRINT»
– The product counter will be reset to 1.
• Print out a balance status
– Ensure that the balance is in the weighing mode
– Keep «PRINT» pressed until “PRINT STATUS” is displayed
– Release «PRINT»
– The balance status will be printed out.
• Print out the application-setup
– Ensure that the balance is in the weighing mode
– Keep «PRINT» pressed until “PRINT APPLICATIONS” is displayed
– Release «PRINT»
– The application-setup will be printed out.
• Print out the calibrations information *
– Ensure that the balance is in the weighing mode
– Keep «PRINT» pressed until “PRINT CALIBRATIONS” is displayed
– Release «PRINT»
– Information on the last 50 calibrations is printed. The time and
date, as well as the temperature in the balance at the time of cal-
ibration in degrees Celsius. If more than 50 calibrations have been
performed, the oldest are deleted.
* not available for firmware Nxx
To Next Page