Precisa 320 XT - Anti-Theft Encoding; Key Tone; Precisa BUS

■ 5 Working with the configuration menu
38
and/or the configuration menu against unintentional changes.
See Chapter 4.7 “Password protection of the menus” and
Chapter 10.1.4 “Activation of password protection” for further
information on password protection.
5.10 Anti-theft encoding
To activate the menu see Chapter 4.5 “Activating the two main me-
nus” and Chapter 4.6 “How the menu control operates”.
If the anti-theft encoding is activated, a four-figure code must be
entered after every interruption of the power supply in order to release
the balance for use.
For further information on the anti-theft encoding see
Chapter 4.8
“Anti-theft encoding”.
To activate the anti-theft encoding, proceed as described for pass-
word protection.
5.11 Key tone
To activate the menu see Chapter 4.5 “Activating the two main me-
nus” and Chapter 4.6 “How the menu control operates”.
If the key tone is switched on, a short audio signal sounds each time
a key is pressed.
5.12 Precisa BUS
To activate the menu see Chapter 4.5 “Activating the two main me-
nus” and Chapter 4.6 “How the menu control operates”.
• THEFTCODE
THEFTCODE
––––
THEFT-PROTECTION ON/OFF Switch encoding
on/off
NEW CODE –––– Enter new code
•KEY TONE
KEY TONE ON/OFF Switch key tone on and off