6 Working with the application menu ■
45
Functions of the application:
Note (not available for firmware Nxx):
By pressing the «MODE»-button you can switch to display the total
load, e.g. to fill-up to a specific weight. Press the «MODE»-button
again to go back to the „NET-TOTAL“ application and its display.
Operation:
Start the application (see Chapter 6.3 “Changing application / weigh-
ing mode”).
• Place something on the weighing pan.
•Press the «REF»-button until the desired function flashes in the dis-
play.
• Release the «REF»-button.
6.8 Application «ANIMAL»
See Chapter 4.5 “Activating the two main menus” and Chapter 4.6
“How the menu control operates” for the activation of the Application
menu.
With the aid of the „AnIMAL” program you can weigh living animals
accurately, even if they move on the scale-pan.
«STO n»: - Take stable value and add to the sum of the
components.
- Tare balance.
- Short confirmation with display „StorEd n“.
«WAIT i»: Value not stabilized yet
«RES»: - Reset
«INF»: - Display of:
- Total weight „TOT“
- Residual capacity „R-C“
- Individual components „n“
- Exit info with «MODE»-button.
•SETUP
APPLICATION
ANIMAL MEASURETIME 4 Enter time in seconds
To Next Page
Loading...
