The TRM600 was initially released with a common frame so there are no new common
frame updates to report for this product line. However, this is a major frame update for the
TRM700 and TRM800 series treadmills. Because the TRM700/800 product lines share the
same base system components, any common frame updates will apply equally to both
product lines. The following is a summary of the TRM700/800 common frame updates:
l Running belt and deck updates:
o
New common frame drive roller
o
New common frame take-up roller and running belt adjustment mechanism
o
Different size running deck
l New landing trim and end cap covers
l New drive belt tension adjustment mechanism
l Redesigned front compartment dust guard (easier drive belt removal)
Ordering Parts
When ordering parts for the TRM700 and TRM800 series treadmills, you will need to
provide the equipment frame type (legacy frame or common frame) to the Precor customer
service representative.
Ways to identify the common frame
l Use the equipment manufacture date:
o
Treadmills built prior to 5/14/2019 use a legacy frame.
o
Treadmills built on or after 5/14/2019 use the new common frame.
l Visual ques to identify the common frame:
o
Check for a drive belt adjustment bolt (yes - common frame, no - ¬legacy
frame).
o
Check the shape of the end cap cover running belt adjustment bolt access hole
(oval - common frame, round - legacy frame).
Common Frame Drive Roller
There are two common frame drive rollers, one for the TRM600 and another for the
TRM700/800 treadmills. The TRM600 treadmill uses a smaller diameter drive roller and not
compatible with the TRM700/800 treadmills. The TRM700 and TRM800 use the same drive
roller.
Both the TRM600 and TRM700/800 drive rollers use the same common frame mounting
system. One end of the roller shaft is a pin that slides into a frame pin mounting hole. The
other end of the shaft is milled to set into a frame mounted bracket. On TRM600 models, the
shaft bracket mount is on the left side of the roller and the shaft pin mount is on the right
side. On TRM700/800 models the frame roller mounts are switched, the shaft bracket
mount is on the right side of the roller and the shaft pin mount is on the left side.
TRM600 Drive Roller
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 236
9 Theory of Operation
TRM600/700/800 Common Frame Overview
To Next Page
Loading...
Need help?
General