INFORMATION DISPLAY DESCRIPTION
that PCA is replaced the hours of use would start again
from "0".
BELT RATING
(1)
(Treadmills with the ASL feature only)
Displays the belt rating from 10 (best) to 0 (worst).
Belt rating ≤ 1 replace the running belt
A belt rating of 0 or 1 will cause a blue pulsing ASL light
indicating that there is a problem with the running belt/-
deck and requires servicing or replacement.
Important: Reset the Belt Rating after replacing with a
new running belt and deck ( hold down QuickStart).
MAINT COUNTER
(1)
Provides machine next maintenance due remaining
mileage or hours. Perform preventative maintenance
when the maintenance counter reaches 0.
Press/Hold the PAUSE/RESET key to reset the counter
(treadmills reset to 1000 miles, ellipticals reset to 250
Hrs).
Belt Maintenance
(2)
(TRM
1
600 only)
Information used to help determine the condition of the
running belt and when the belt needs to be replaced.
Belt Maintenance provides the averaged input current
values at 6, 8, and 10 mph across 50 workouts. Meas-
urements are only taken when AutoStop is ON and the
incline is set to 0%.
BELT HOURS: belt usage hours
AV-AMP-6MPH: averaged current a 6 mph
AV-AMP-8MPH: averaged current a 8 mph
AV-AMP-10MPH: averaged current a 10 mph
Belt condition/disposition based on typical AC
2
input cur-
rent values:
Normal: 8 -12 A (120Vac) / 4 - 6 A (240Vac)
Worn: ≥ 16-18 A (120Vac) / ≥ 8-9 A (240Vac)
Replace: ≥ 19 A (120Vac) / ≥ 9.5 A (240Vac)
Max Amps: 20 A (120Vac) / 10A (240Vac)
U-BOOT SW The console upper boot software version information.
U-BASE SW or
MAIN CONSOLE SW*
The console upper base software version information.
*P31 console only.
1
Treadmill
2
Alternating Current: electric current which periodically reverses direction between positive
and negative polarity.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 41
4 Standard Service Menus
LED Console Standard Service Menus
To Next Page
Loading...
Need help?
General