8. Reinstall the extension tube into the lift platform mounting bracket and secure using
the hitch pin and clevis pin. It may be necessary to slightly rotate the extension tube to
align the clevis pin mounting holes. Choose an adjustment direction that will minimize
the change to the extension tube calibration distance. Firmly hold the jackscrew from
turning while adjusting (rotating) the extension tube.
Operation Verification
9. Return the treadmill to the upright position resting on the rear leveling feet and lift plat-
form wheels, see either the "Side access" on page 76 or the "Front access" on the
next page. Make sure the treadmill is stable and setting level on the floor.
10. Reinstall the hood.
11. Connect the power cord and switch the power ON.
12. Verify incline operation from the minimum to maximum levels. Verify that the incline
reaches maximum and minimum levels and the up/down movement is smooth. Verify
that there are no unusual noises.
13. Review the Error Log and verify that there are no active Incline function related error
codes.
14. Do the Operation Verification tests (see "Operation Verification" on page 23) and
return to service.
Contact Precor Customer Support at support@precor.com or 800.786.8404 with
any questions.
Page 73
5 Adjustment Procedures
Lift Motor Calibration
To Next Page
Loading...
Need help?
General