TRM 211 Owner's Manual 40
Selecting a U.S. Standard or
Metric Display
The treadmill can display measurements in either
METRIC or U.S. STANDARD. The default factory
setting is set to display U.S. STANDARD. To change
this setting, perform the following steps:
1. Remove the magnetic safety key.
2. Replace the magnetic safety key and within 2
seconds press the following keys:
S
TOP, INCLINE
t and SPEED t
3.
UNIT CHANGE appears in the display. Press
ENTER to continue or press STOP to return to the
banner.
4. If you press ENTER, the current unit of measure
(US STANDARD or METRIC) appears in the
display.
Any arrow key lets you alternate between the
prompts.
Note: Changing the display to metric
measurements affects the default settings.
Distances and the odometer values are converted
to and appear in kilometers (KM). Speed appears
in kilometers per hour. If you use QUICKSTART,
the weight is set at 68 kg.
5. Press ENTER to accept the displayed setting.
The change will be retained in memory even if the
treadmill is turned Off and unplugged.
6. If you want to exit without saving the change,
press STOP.
303207-110 rev A TRM 211 Owner's Manual 031914 EN-US - body only with crops.pdf 40 3/25/2014 12:55:22 PM
To Next Page
Loading...
Need help?
General
