TRM 211 Owner's Manual 46
To order parts or to contact a Precor authorized
service provider in your area, contact Precor Customer
Support.
Important: You should not attempt to service the
treadmill except for maintenance tasks as described in this
manual. The treadmill does not contain any
user-serviceable parts that require lubrication. For
information about product operation or service, see the
Precor web site at www.precor.com. For future reference,
write the model, serial number, and date of purchase for
your unit in the space provided. The serial number is
printed on a label located on the front panel, near the
power cord (refer to Obtaining Service).
Cleaning the Equipment
Most of the working mechanisms are protected inside
the hood and base of the treadmill. However, for
efficient operation, the treadmill relies on low friction.
To keep the friction low, the unit’s running belt, staging
platforms, and internal mechanisms must be as clean
as possible.
Precor recommends the treadmill be cleaned before
and after each workout. Use mild soap and water to
dampen a soft cloth and wipe all exposed surfaces.
This helps remove any dust or dirt.
CAUTION: Do not use any acidic cleaners. Doing so will
weaken the paint or powder coatings and void the Precor
Limited Warranty. Never pour water or spray liquids on
any part of the treadmill. Allow the treadmill to dry
completely before using.
Frequently vacuum the floor underneath the unit to
prevent the accumulation of dust and dirt, which can
affect the smooth operation of the unit. Use a soft
nylon scrub brush to clean the running belt.
303207-110 rev A TRM 211 Owner's Manual 031914 EN-US - body only with crops.pdf 46 3/25/2014 12:55:22 PM
To Next Page
Loading...
Need help?
General
