TRM 211 Owner's Manual 42
Red Reset Button
A red button, near the power switch, resets the
treadmill’s circuit breaker. If the running belt stops
unexpectedly and all display console functions cease,
the circuit breaker may have been tripped.
To reset the system, take the following steps:
1. Use the power switch beneath the front panel to
turn the treadmill Off.
2. Make sure the treadmill is positioned away from
heating ducts. If necessary, move the treadmill to
an appropriate place (refer to Location).
3. Wait a few minutes. Make sure the magnetic
safety key is properly positioned on the display
console.
4. Push the red reset button, and then turn the
treadmill On.
5. Check the display to verify that the Precor banner
is scrolling across the display. If the display
remains blank, call Precor customer support.
Important: You should not attempt to service the
treadmill except for maintenance tasks as described in
this manual. The treadmill does not contain any
user-serviceable parts that require lubrication. For
information about product operation or service, see the
Precor web site at www.precor.com. For future
reference, write the model, serial number, and date of
purchase for your unit in the space provided. The serial
number is printed on a label located on the front panel,
near the power cord (refer to Obtaining Service).
303207-110 rev A TRM 211 Owner's Manual 031914 EN-US - body only with crops.pdf 42 3/25/2014 12:55:22 PM
To Next Page
Loading...
Need help?
General
