Getting Started
3
Unpacking the Equipment
The treadmill is carefully tested and inspected before shipment. The unit is
shipped in two boxes. Ask for help from two or more people to unpack and
assemble the treadmill. If any items are missing, contact your dealer.
Do not attempt to move the equipment by yourself. Have at
least one other person help you and use proper lifting
techniques.
To unpack the equipment:
1. Carefully cut and remove all plastic straps that secure the cover on the
cardboard box.
2. Lift the cover upward and set it aside.
3. Pull the cardboard or foam spacers away from the equipment and set them
aside.
4. Cut all plastic ties securing the equipment in place.
5. Remove the base frame assembly from the container and set it on the floor
where you plan to assemble and use the equipment.
Required Tools
Phillips-head screwdriver
17 mm open-end wrench
Level
Wire cutter
Hardware Kit (not to scale)
The hardware kit shipped with this equipment contains the fasteners and other
hardware components shown in the following table. Before you begin assembly,
make sure that your hardware kit is complete. If not, please contact Precor
Customer Support.
Table 1. Hardware kit contents
Fasteners
Quantity
Buttonhead screw
(M8 x 15 mm)
10
Washer
(8.4 mm)
14
Socket head screw
(M8 x 15 mm)
4
Buttonhead screws
(M6 x 15 mm)
4
Washer
(6.5 mm)
4
Buttonhead screw
(M5 x 10 mm)
2
Washer
(5.2 mm)
2
5 mm hex key 1
4 mm hex key 1
To Next Page
Loading...
Need help?
General
