© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 99
6 Fasten the power control module with the four screws removed in step
4.
7 Reconnect the COMM, INCLINE, INPUT, DB and OUTPUT connectors removed
in step 3. The mating connectors on the power control module are
polarized, therefore they cannot be reconnected incorrectly.
8 Replace the treadmill’s hood.
9 Thoroughly check the treadmill per, Checking Treadmill Operation (see
"Section 4 - Operation Verification" on page 9).
To Next Page
Loading...
