© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 12
Service Access Codes .............................. 12
Accessing the Service Software .................... 12
Access Code Table ................................. 14
P20 Console Service Software Access ............... 15
Hardware Validation - Diagnostic Tests (51765761) . 16
Club Parameter - Settings (5651565) ............... 17
Information Display (65) .......................... 18
Service Access Codes
The standardized service access codes are utilized on the following
consoles:
Standard Console
P10 Console
P20 Console
P30 Console
The service codes will allow access to three functional modes, Hardware
Validation, Club Parameters, and a Information Display.
Hardware Validation is a set of functional diagnostic tests that are
useful in troubleshooting problems as well as verifying proper
operation.
Club Parameters are sometimes referred to as Club Settings and are
used to manage usage of the machine.
Information Display is used to access information such as the
odometer, software versions and error logs.
Accessing the Service Software
Accessing these three areas is accomplished the same on all consoles
(Standard, P10, P20, P30) except the P80. To enter Service Software,
press either the STOP, PAUSE, or RESET key (whichever is available on
your specific console) followed by a numeric code for the area of service
software you wish to access.
Section 5 - Standardized Service Access
Codes
To Next Page
Loading...
