© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 92
Replacing Drive Motor
1 Set the treadmill's on/off switch in the off position and unplug the
treadmill’s line cord from the AC outlet.
2 Remove the hood.
3 Disconnect the drive motor connector from the OUTPUT connector on the
power control module.
4 Remove the drive belt from the drive motor.
5 Mark the outline of the current motors mounting plate for reference
when you install the new motor.
6 Remove the four bolts that fasten the drive motor to the frame.
7 Set the replacement drive motor in its mounting position and fasten
the drive motor with four mounting bolts removed in step 5 and fasten
the drive motor with four mounting bolts removed in step 6.
8 Place the drive belt on the drive roller pulley and on the drive motor
pulley.
9 Adjust the drive belt tension and complete the motor installation per
Procedure, Adjusting Drive Belt Tension.
10 Thoroughly check the treadmill per, Checking Treadmill Operation (see
"Section 4 - Operation Verification" on page 9).
To Next Page
Loading...
Need help?
General