© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 115
11 Reinstall the Auto Stop magnet on the right front corner of the deck,
if applicable.
Figure 52: Auto Stop Assembly
12 Slide the take up roller though the running belt and positing in the
frame. Hand tighten the mounting bolts into the take up roller shaft.
13 Align the bottom plate and pivot bracket holes with the running deck
bolt holes.
14 Replace the roller guard and mounting bolts. Only hand tighten the
bolts at this time.
15 Verify the spacing on all four corners that they are the same.
To Next Page
Loading...
