© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 10
Concentrate on the feel of the running belt, the sound of the drive
motor and rollers. Be on the alert for unusual noises, smells or
vibrations.
Observe the LED’s on the electronic console. Make sure that each LED
lights as the information corresponding to that LED is displayed on
the electronic console.
10 Press the INCLINE key while viewing the electronic console. Confirm
that the running deck inclines and the incline display increments to
15% as the INCLINE key is continually pressed.
11 Press the INCLINE key while viewing the electronic console. Confirm
that the running deck returns to a level position and the incline
display decrements to 0% as the INCLINE key is pressed. (Depending
on the software configuration of the console, the lowest level of
incline might be -3%)
12 While the unit is running and the running belt is in motion, press the
STOP button and verify the running belt stops.
13 Restart the running belt and while the running belt is in motion, pull
the ESTOP cord and verify the running belt stops.
14 Press and hold the reset key for at least 6 seconds and look at the
error log again. This time look for any NEW errors displayed resulting
from the verification test indicating that the unit needs attention.
To Next Page
Loading...
Need help?
General