© Precor Incorporated, Unauthorized Reproduction and Distribution Prohibited by Law Page 128
2 Vacuum the carpet or "damp mop" the floor underneath the treadmill.
3 Make sure the floor is dry before returning the treadmill to the level
position. Re-connect the power cord and turn the switch/circuit
breaker to the "ON" position. The elevation should perform an auto-
return to the home position.
Running Belt and Deck Cleaning Procedure
4 First, check for proper operation of the safety stop key. Stand to one
side of the treadmill. Ensure that the stop key tether is hanging
straight down from the stop key and is not wrapped around the handle
bars. Push the Quick Start button and wait for the display to count
down and for the running belt to begin moving. Once the running belt
is moving pull the safety stop key tether. See the Figure Below. When
the belt stops reset the safety stop key.
Figure 60: Running Belt and Deck Cleaning
CAUTION: If the running belt does not stop, turn off the power using the
ON/OFF switch at the front of the treadmill and unplug the power cord.
The treadmill must remain out of service until the stop switch is
repaired. If the running belt stops, continue with the cleaning procedure
5 A clean, dry towel approximately 36 inches or 1 meter in length is
required. Fold the towel in half lengthwise, lift the running belt up
and insert the towel beneath the belt so that an end of towel extends
on to each deck trim. See the Figure Below.
6 Stand to one side of the treadmill, push the Quick Start button, grasp
the towel as illustrated in the illustration above. Note: You will
have 3 seconds to firmly grasp your hands on the towel before the
treadmill running belt begins to move. Allow the treadmill to run for
about one minute while holding the towel firmly in place.
To Next Page
Loading...
Need help?
General