6–14
Replacement Procedures and Parts
13. Remove the hammer bank (17): (See Figure 6–2.)
a. Note the U–shaped shims (18) installed at the end of the shuttle
spring (22). Do not lose these shims while removing the hammer
bank.
b. Firmly gripping the right and left shuttle shroud screws (24) with
your right and left thumbs, slowly lift the hammer bank while
keeping the shuttle shroud, hammer bank cables, and antirotation pad
in place.
c. Be careful that the left linear bearing sleeve (23) does not slip off the
shaft or that the hammer bank cables catch on any exposed edges of
the printer.
To Next Page