10
4.3 Turning On The i4s
Power
Switch
3 Phase
Indicator
1. The 3-phase indicator (3 LEDs on the front panel) should always be illuminated while the welder
is plugged in (verify this before turning on the power). Switch the circuit breaker on the front panel
to “ON”.
2. The display will go through the start-up procedure.
3. The i4s is now ready to use.
IMPORTANT! Make sure to read the instruction manual before operating
the welder. Only trained personnel should use this welder.
IMPORTANT! Assurez-vous de lire le Mode d’Emploi avant d’opérer le
!
When in use - the i4s discharges a large
effect medical implant devices such as
pacemakers.
When in use - The i4s discharges a large
electronics and attract metal to the gun.
Unplug the welder from the wall
outlet before servicing, cleaning, or
maintenance. Risk of electrical shock.
Some parts of the welder may become
hot after prolonged use.
Always wear eye protection when
welding. Showers of sparks will
welded.
Be wary of pinch points on the i4s such
as the electrodes / weld caps on the
double-sided gun.
WARNING! READ THE FOLLOWING BEFORE WELDING
4.3 Turning On The i4s
Figure 4.4
To Next Page
Loading...
