Prodigy Autocode User Manual

Owner’s Manual
AutoCode
®
Blood Glucose Meter
44
Repeat Feature: After the test result is spoken, you may
press the “M” button to hear the result again.
The blood glucose test result is automatically stored in
the meter’s memory. Turn the meter off by removing the
test strip. Discard the used test strip appropriately.
Important: If you do not apply a blood sample with
-
in three (3) minutes, the meter will automatically turn
off. You must remove the test strip and re-insert it in
order to turn on the meter and restart the testing
procedure.
Caution: If you cannot test due to a problem with
your testing supplies, contact Customer Care at
1.800.243.2636. Failure to test could delay treatment
and/or lead to serious medical conditions.

Prodigy Autocode Specifications

General

Measurement Range	20-600 mg/dL
Sample Size	0.6 µL
Test Time	6 seconds
Coding	No Coding Required
Battery Type	2 x AAA batteries
Automatic Shutoff	2 minutes
Data Port	USB
Operating Conditions	50-104°F (10-40°C)
Memory Capacity	Up to 450 test results