To empty your tanks
1. Turn the protective cap to the left to remove it.
2. Attach the sewage hose to the tankoutlet and rotate to secure it in the closed
position. On sometrailers, the outlet can be turned downward for better flow.
3. Place the other end of the waste waterhose in an approved cleanout intake.
Place it far enough into the opening. In some cases, an adaptor may be required.
Position the hose at a uniform slope into the cleanout intake and avoid sharp bends,
which can create a blockage.
4. Open the black water valve to empty the tank and hold the valve handle. Once the
tank is empty, press on the valve handle to close the opening. After emptying the
tank, it is best to add some water to the tank through the toilet as well as some
waste tank deodorant.
5. To empty the grey water tank, connect the hose and open the grey water tank valve
to empty the tank. Always empty the grey water last, for better cleaning of the waste
water hose. Once the tank is empty, close the grey water trap.
6. Disconnect the sewage hose from the trailer and reinsert the cleanout
protective cap.
7. Rinse the sewage hose with fresh water and remove it from the cleanout station.
8. Reinsert the cleanout station cap and stow your hose and connection in their
proper place.
WASTE WATER SYSTEM
Do not use the drinking water hose to rinse a sewage tank. Noxious or
toxic matter might come into contact withthe drinking water hose and
contaminate the drinking water in your supply system, tank and
plumbing. Always use a different hose to rinse components in the
sewage system.
WARNING
100
100
To Next Page
Loading...