Never leave the water pump running when the drinking water tank is
empty or when travelling with your towing vehicle, as this can damage
the pump or circuit.
WARNING
Municipal water connection
The trailer is connected to a municipal water
system by a drinking water hose from a
connector on the trailer’s exterior.
To connect to a municipal water system
1. Turn your water pump switch to the OFF position.
(Since the connectionis pressurized, youwill not need the water pump.)
2. Take out the drinking water hose.
3. Open the municipal water supply and let the water run for a few seconds or until the
water is clean and clear. Close the supply tap and connect the drinking water hose
to the municipal water supply.
DRINKING WATER SYSTEM
Your water pump must be winterized. See the “Storage” section for
details.
When municipal water pressure is low at your campsite, you can activate
the water pump to boost the flow.
HINTS AND TIPS
089
89
To Next Page
Loading...