Test the GFCI every year when you are connected to 120-volt AC current, by performing
the following steps.
1. Press the TEST button. The RESET button should pop out, indicating that the
circuit has been disconnected.
2. If the RESET button does not pop out when the TEST button is pressed, there is a
defect and you must have your dealer or a qualified electrician check your trailer.
Do not use the system until the problemhas been corrected.
3. Press the RESET button to reset the breaker and restore current.
ELECTRICAL SYSTEM
If your bathroom, exterior outlets, etc. are not working, check the
breaker and reset it if necessary. If the breaker continues to trip, contact
a qualified electrician.
083
83
To Next Page
Loading...