Before filling the tank, ensure that the water supply is of good quality,
drinkable and free of contaminants.
Filling the drinking water tank by gravity
1. Ensure that the drinking water drain valve is closed.
2. Connect one end of the drinking water transfer hose to the water
supply source, then open the water and let it flow until it runs
clean and clear. Turn off the feed.
3. Open the water intake tank cover.
4. Place the other end of the hose in your trailer’s water intake.
Open the water feed and fill the tank until water begins to run out
the overflow provided for this purpose, above the water intake.
5. Remove and stow the hose in a clean location.
6. Close the cap on the water intake tank.
DRINKING WATER SYSTEM
Ensure that you always store your drinking water hose in a clean location
away from sources of contamination. It must be used only to fill your
drinking water tank or connect to municipal water.
CAUTION
087
87
To Next Page
Loading...