ProMinent DULCO flex Control - Default Chapter; Table of Contents

Table of contents
1
Supplementary operating instructions for CANopen............. 4
1.1 About this pump............................................................ 4
1.2 Control elements........................................................... 5
1.3 Electrical installation..................................................... 5
1.4 Emergency mode.......................................................... 7
1.5 Troubleshooting............................................................ 7
1.6 Accessories.................................................................. 8
1.7 Appendix....................................................................... 8
1.7.1 Object list for metering pump DULCO flex Control
DFXa, DFXa..............................................................
8
1.7.2 Communication profile area 0x1000-0x1FFF............ 8
1.7.3 Manufacturer-specific profile area
0x2000-0x5FFF......................................................... 9
1.7.4 Device profile area 0x6000-0x9FFF........................ 13
1.7.5 Alarm action area for measurement devices
(404 )....................................................................... 18
1.7.6 EMERGENCY.......................................................... 18
1.7.7 Explanations of objects............................................ 20
1.7.8 Changing the CANopen node address (Node ID)... 21
1.7.9 Transfer rate (baud rate).......................................... 22
1.7.10 Calibration, explanations....................................... 22
1.7.11 Firmware update.................................................... 22
1.7.12 Data storage.......................................................... 22
1.7.13 Directives / standards complied with..................... 23
2 Supplementary operating instructions for Modbus RTU..... 24
2.1 About this Modbus pump............................................ 24
2.2 Control elements......................................................... 25
2.3 Electrical installation................................................... 25
2.4 Setting options for the pump control elements........... 27
2.5 "Modbus RTU" implementation................................... 28
2.5.1 "Modbus RTU" message structure.......................... 29
2.6 Device monitoring....................................................... 30
2.7 Emergency mode........................................................ 31
2.8 Faults.......................................................................... 31
2.9 Accessories................................................................ 31
2.10 Modbus RTU for Prominent pumps register............. 32
2.10.1 "Device identification" register............................... 32
2.10.2 "Modbus" register.................................................. 33
2.10.3 "Production data pump module-specific" register.. 34
2.10.4 "Production data Modbus module-specific" reg‐
ister........................................................................ 34
2.10.5 "Current operating parameters" register................ 36
2.10.6 "Target operating parameter" register................... 39
2.10.7 "Advanced configuration" register.......................... 41
2.10.8 "Accessories 1" register......................................... 43
2.10.9 "Accessories 3" register......................................... 43
2.10.10 "Debug data" register........................................... 44
3
Supplementary operating instructions for PROFIBUS
®
...... 46
3.1 Requirements............................................................. 46
3.2 Adjusting the pump..................................................... 46
Table of contents
2