ProMinent DULCO flex Control Original Operating Instructions

2 Supplementary operating instructions for Modbus RTU
2.1 About this Modbus pump............................................ 24
2.2 Control elements......................................................... 25
2.3 Electrical installation................................................... 25
2.4 Setting options for the pump control elements........... 27
2.5 "Modbus RTU" implementation................................... 28
2.5.1 "Modbus RTU" message structure.......................... 29
2.6 Device monitoring....................................................... 30
2.7 Emergency mode........................................................ 31
2.8 Faults.......................................................................... 31
2.9 Accessories................................................................ 31
2.10 Modbus RTU for Prominent pumps register............. 32
2.10.1 "Device identification" register...............................
32
2.10.2 "Modbus" register.................................................. 33
2.10.3 "Production data pump module-specific" register.. 34
2.10.4 "Production data Modbus module-specific" reg‐
ister........................................................................ 34
2.10.5 "Current operating parameters" register................ 36
2.10.6 "Target operating parameter" register................... 39
2.10.7 "Advanced configuration" register.......................... 41
2.10.8 "Accessories 1" register......................................... 43
2.10.9 "Accessories 3" register......................................... 43
2.10.10 "Debug data" register........................................... 44
2.1 About this Modbus pump
Metering pumps DULCO flex Control DFXa with a "Modbus RTU"
connection differ from standard pumps by way of the option to con‐
nect to a "Modbus RTU" bus system. A "Modbus RTU" pump
DULCO flex Control DFXa can either be connected to a "Modbus
RTU" bus or be used as a stand-alone unit.
Example:
n Measured value-dependent metering of sodium-calcium hypo‐
chlorite into a swimming pool water circuit, where the pump is
controlled by a PLC in
‘Modbus RTU’ operating mode.
A "Modbus RTU" version of the DULCO flex Control DFXa (identity
code feature "Control option" = M) is intended for integration into a
"Modbus RTU" system.
This document contains general information for the implementation
of the metering pump DULCO flex Control DFXa, DFXa into the
serial communication protocol of the Modbus RTU.
Supplementary operating instructions for Modbus RTU
24

ProMinent DULCO flex Control Specifications

General

Brand	ProMinent
Model	DULCO flex Control
Category	Water Pump
Language	English