To Next Page

To Previous Page

1 Supplementary operating instructions for CANopen

1.1 About this pump............................................................ 4

1.2 Control elements........................................................... 5

1.3 Electrical installation..................................................... 5

1.4 Emergency mode.......................................................... 7

1.5 Troubleshooting............................................................ 7

1.6 Accessories.................................................................. 8

1.7 Appendix....................................................................... 8

1.7.1 Object list for metering pump DULCO flex Control

DFXa, DFXa..............................................................

1.7.2 Communication profile area 0x1000-0x1FFF............ 8

1.7.3 Manufacturer-specific profile area

0x2000-0x5FFF......................................................... 9

1.7.4 Device profile area 0x6000-0x9FFF........................ 13

1.7.5 Alarm action area for measurement devices

(404 )....................................................................... 18

1.7.6 EMERGENCY.......................................................... 18

1.7.7 Explanations of objects............................................ 20

1.7.8 Changing the CANopen node address (Node ID)... 21

1.7.9 Transfer rate (baud rate).......................................... 22

1.7.10 Calibration, explanations....................................... 22

1.7.11 Firmware update.................................................... 22

1.7.12 Data storage.......................................................... 22

1.7.13 Directives / standards complied with..................... 23

1.1 About this pump

Metering pumps DULCO flex Control DFXa with CAN connector

differ from standard pumps in that they can be connected to a

CANopen bus system. A CAN pump DULCO flex Control DFXa

can be connected to a CANopen bus or used as a standalone unit.

Example:

n Measurement value-dependent metering of sodium-calcium

hypochlorite into a swimming pool water circuit, in

‘CANopen’

operating mode, the pump being controlled by a controller.

A "CANopen" version of DULCO flex Control DFXa (Identity code

feature "Control type" = C or D) is designed for incorporation in a

CANopen system.

Supplementary operating instructions for CANopen

ProMinent DULCO flex Control Original Operating Instructions

Other manuals for ProMinent DULCO flex Control