Proteco Q80A - 4.2.2 Restoring DEFAULT SETTINGS; RAM Opener Default Settings; ARTICULATED ARM Opener Default Settings; WHEEL-DRIVEN Opener Default Settings

Q80A_8_2017 16
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
ARTICULATED ARM opener default settings
1 Use buttons to move inside the menu, till the display shows:
2 Press and hold button for about 5 seconds.
3 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
WHEEL-DRIVEN opener default settings
1 Use buttons to move inside the menu, till the display shows:
2 Press and hold button for about 5 seconds.
3 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
RAM opener default settings
1 Use buttons to move inside the menu, till the display shows:
2 Press and hold button for about 5 seconds.
3 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
4.2.2 Restoring DEFAULT SETTINGS
The control panel comes with pre-set working parameters according to the automation model used.
You can reset the control panel to the default settings as follows: