Proteco Q80A User Manual

....
....
Q80A_8_2017 26
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
OPERATING TIME – Motor 2
Use this menu to adjust Motor 1 opening/closing.
Use only with the SEQUENTIAL Programming mode .
In AUTOMATIC programming mode working time of MOTOR 2 can't be changed.
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
3 Use buttons to reduce/increase Motor 2 operating time:
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
DECELERATION TIME – Motor 1
Use this setting to adjust opening/closing deceleration time for Motor 1 (from 1 to 10 seconds)
Before adjusting this setting, please make sure that parameter in FUNCTIONS menu is:
= Deceleration ON
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
3 Use buttons to reduce/increase Motor 1 deceleration time:
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
(max)
(OFF)
(max)
(min)

Proteco Q80A Specifications

General

Brand	Proteco
Model	Q80A
Category	Control Panel
Language	English