19 Q80A_8_2017
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
PRE-BLINKING Function
This function makes the flashing light pre-blinking for 4-5 seconds before the gate starts opening.
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
3 Use buttons to select:
PRE-BLINKING Function OFF
PRE-BLINKING Function ON
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
4.4 FUNCTIONS menu
Use this menu to enable/disable special settings.
= function is ON
= function is OFF
Press button and use to select menu ,
then press button to enter the FUNCTIONS menu: display will show
Use buttons to scroll the lower level menus:
MULTI-OCCUPATION Function
This function grants priority to the opening command; when two people activate the gate
at the same time the first opening command prevails, while opening the control panel ignores
any further command.
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
3 Use buttons to select:
MULTI-OCCUPATION Function OFF
MULTI-OCCUPATION Function ON
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
To Next Page
Loading...
Need help?
General
