....
....
Q80A_8_2017 18
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
OBSTACLE DETECTION adjustment - MOTOR 1
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
The display now shows the current sensibility level for the obstacle detection of Motor 1:
3 Use buttons to change the Motor 1 sensibility level
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
OBSTACLE DETECTION adjustment - MOTOR 2
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
The display now shows the current sensibility level for the obstacle detection of Motor 2:
3 Use buttons to change the Motor 2 sensibility level.
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
(OFF)
(max)
(min)
(min)
(max)
(OFF)
N.B.:
NOTE: If OBSTACLE DETECTION is too sensitive, causing unexpected stops or reversal of leaves, you need to
re-adjust and settings to a lower level.
To Next Page
Loading...
Need help?
General
