....
....
23 Q80A_8_2017
PROTECO S.r.l.
Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
FINAL MOTOR RELEASE in CLOSING – Motor 1 only
Use only with the AUTOMATIC Programming mode -
This setting makes motor 1 to release the push a little bit once the gate is fully closed.
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
3 Use buttons to select the level of the FINAL MOTOR 1 RELEASE
when CLOSING:
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
FINAL MOTORS RELEASE in OPENING – Motor 1 and 2
Use only with the AUTOMATIC Programming mode -
This setting allows both motor to release a little bit the push once the gate is fully open.
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm.
3 Use buttons to select the level of the FINAL MOTORS RELEASE when OPENING:
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
FLASHING LIGHT mode selection
Use this settings to select the signal mode of the falshing light according to the blinker model you have.
1 Use buttons to move inside the menu, till the display shows:
2 Press button to confirm
3 Use buttons to select:
BLINKING signal (Standard Flashing Light)
FIX signal (LED Flashing Light)
4 Press button to go back to the top level menus,
then press button again till the display shows:
or wait the timeout (20 seconds) to exit.
(OFF)
(max)
(min)
(OFF)
(max)
(min)
To Next Page
Loading...
Need help?
General
