Proteco Q80A - CLOSING DELAY between Leafs AUTOMATIC CLOSING Pause Time

PROTECO S.r.l. Via Neive, 77 - 12050 Castagnito (CN) ITALY Tel. +39 0173 210111 - Fax +39 0173 210199 info@proteco.net - www.proteco.net
TIMES Menu
OPENING DELAY between leafs
CLOSING DELAY between leafs
AUTOMATIC CLOSING pause time
PEDESTRIAN CLOSING pause time
OPERATING TIME – Motor 1 SEQUENTIAL Programming procedure only
OPERATING TIME – Motor 2 SEQUENTIAL Programming procedure only
DECELERATION TIME – Motor 1
DECELERATION TIME – Motor 2
PEDESTRIAN OPENING time
ACCESSORIES Menu
EMERGENCY STOP terminals
CLOSING PHOTOCELLS terminals
OPENING PHOTOCELLS/ SAFETY EDGE terminals
= OFF
(min).... ( )...... (max)
= OFF
(min).... ( )...... (max)
= OFF
(min).... ( )...... (max)
= OFF
(min).... ( )...... (max)
= OFF
(min).... ( )...... (max)
(min).... ( )...... (max)
= DISABLED
= ENABLED/WIRED
= DISABLED
= ENABLED/WIRED
= DISABLED
= Opening photocells WIRED
= Safety Edge (NC) WIRED
= Safety Edge 8K2 WIRED
Display MESSAGES
Stand-by. Control Panel ready to work
Closing PHOTOCELLS operating
Opening PHOTOCELLS operating
STOP operating
START operating
PEDESTRIAN START operating
Receiving a radio code (12/24 bit)
Obstacle detection intervention
Programming settings have been saved
Rotating dashes: motors are working
Dots between dashes: the brighter dots are the higher is the force setting ( and )
= OFF
(min).... ( )...... (max)
= OFF
(min).... ( )...... (max)
= OFF
(min).... ( )...... (max)
Quick spinning = motors running in standard speed
Slow rotating = motors running in deceleration
= Complete opening leaf 1