43
Assigning Sample Type and ID
The Sample Type and ID are set from the sample ordering screen (Figure 42). The default Sample Type is
Patient. The default ID is blank.
Figure 42
Auto Sample Order Off
This option allows the user to assign the same sample ID to multiple tubes. The sample ID entry does not need
to be repeated for each applicable tube.
QC Samples
◼ Select QC from the Sample Type drop-down list (Figure 42).
◼ An instruction to scan the QC barcode is displayed (Figure 43).
Note: QC sample IDs are entered using a barcode scanner only.
Figure 43
◼ To enter the ID of the QC sample, touch the button to confirm the selection of a QC sample.
◼ If QC sample type was entered in error, touch the exit button. The Sample Type reverts to Patient.
See instructions above for Patient Samples.
To Next Page
Loading...
Need help?
General