Extended Manual for RF919 v2.1
© 2024 page 12 of 63
1. Carefully flip out the rod antenna located at the top of the radio and direct
it towards the sky.
2. Carefully extract the rod antenna to its maximum length.
3. Short press [ ] or [ ] just to turn on the backlight
4. Immediately thereafter, short press [ ] to power on the radio.
5. The radio should now be in “FM” receive mode. If not, press [ ] until it is
in “FM” receive mode
6. Long press [ ] to scan the current frequency band and store all found
radio stations to separate channels. This process may take some minutes.
“ ” will be blinking on the primary display during the process. You
will hear the first radio station found as soon as the scan process has
completed.
7. Short press [ ] until “ ” is constantly displayed on the primary
screen. This turns on the channel mode with the channels stored in the
previous step being easily available.
8. Use [ ] and [ ] to select one of the stored radio stations.
9. Use [ ] and [ ] to align the volume as required.
Now listen to your new RF919. Whilst doing so, read the remaining pages
of this manual.
Long press [ ] to turn off the radio.
To Next Page
Loading...
