Extended Manual for RF919 v2.1
© 2024 page 28 of 63
7.3.4.3 Search and store active radio stations using the SCAN-key
In receive mode, long press [ ] for 2 seconds to search for active radio stations
and store their frequencies automatically as channels in the huge memory of the
radio. During the automatic search, the currently scanned frequency is displayed
on the primary screen. Whenever an active frequency has been detected,
“CH***” appears on the primary screen, with “***” being the latest stored
channel number and the frequency of that radio station gets automatically stored
in the next available free channel.
After a search round, search will stop automatically, and the first channel stored
will be selected.
Every frequency band, except the Weather Band (WB), can hold up to 200
channels. This results in a total of 1,600 channels. The Weather Band WB has 7
fixed channel assignments as listed in chapter 7.3.9 “Weather Band of North
America” on page 30.
Note: The number of automatically stored channels depends on the local signal
strength of the stations.
7.3.4.4 Search by rotating the tuning knob
In receive mode, rotate the inner or outer tuning knob [ ] at the front of radio to set
the receive frequency. Rotate the outer tuning knob [ ] to progressively
increase/decrease at the minimum step value of the currently selected
frequency band. Short press the small tuning knob [ ] to select a step value.
Rotate the big tuning knob [ ] clockwise or anti-clockwise to select the frequency
you need according to the selected step value.
The adjustable step values for the various bands are as follows:
To Next Page
Loading...
