Extended Manual for RF919 v2.1
© 2024 page 51 of 63
14.1 Turn off the alarm time
Select "1 OFF" or "2 OFF" as described at the beginning of the chapter. After
selecting “OFF”, the alarm clock symbol of the secondary screen will disappear.
Note: If scheduled power on “ ” is selected and scheduled power off time of 10-
20-30-40-50-60-70-80-90 minutes are selected, the radio will be turned off
on schedule and the sleep symbol " " will appear on the secondary screen.
After setting the scheduled switch-on and wake-up time, press [DISPLAY]
briefly when the radio is switched on or the time is displayed to check the
alarm times of “ ” and “ ”.
14.2 Confirm alarm
Whenever the alarm type is “radio”, the radio will automatically turn on with its
last operating mode preselected. The “sleep mode”-symbol “ ” is displayed on
the secondary screen. A confirmation of any kind is not required. The radio will
stay on if the alar duration had been set to “FULL”. If it has been set to any other
value, the radio will automatically turn off after the specified time.
Whenever the alarm type is “bu2”, the buzzer will sound with the specified ring
melody. The volume will be constantly increasing.
By pressing the inner tuning knob [ ], the melody will be paused for 5 minutes
and the alarm symbol “ ” / “ ” displayed on the secondary screen will be
flashing during that time.
Long press [ALARM] to confirm the alarm. The alarm is confirmed for now, but will
again sound the next day at the very same time.
To Next Page
Loading...
