25
Scanner Setup
• Some Global parameter changes do not take
effect until the Global menu is saved.
• Help is available for every menu parameter.
Press FUNC SEL to view help for the selected
parameter. Press SEL to exit help.
• The Undo softkey appears in fields where
numerical values can be set, allowing you to
exit a parameter field without saving changes.
A note will appear: “Unsaved Changes! Go
Back?
” Press YES to go back to the field and
continue editing. Press NO to discard changes
and return to the previous menu.
• Each menu parameter features a Dflt softkey
that can be used to restore the value to the
factory defaults. This can be very useful if you
make a change to a parameter but do not like
the result.
• You can restore all Global settings to their
defaults without affecting your programmed
objects or V-Scanners. Power cycle the radio,
then press 0, then 2 during the welcome
message display. Press ENT to confirm the
Global parameter reset.
To access GLOB menu:
1. Press PGM for Program Mode.
2. Press
GLOB softkey to access Global menu.
3. Press p or q to scroll to the desired parameter.
Note: Press FUNC p or FUNC q to jump to the
top or bottom of the menu.
4. Press t or u to select options for selected
field.
5. Press SAVE softkey to save new settings to
radio configuration memory.
To Next Page
Loading...
