97
Additional Information
Reset Global Parameters to Factory Defaults
If your scanner does not appear to be functioning
properly, you can reset the global radio
parameters to their factory state without losing
any of your programmed data. Any custom
changes you have made to the radio’s global
parameters will be lost.
Note: This procedure preserves the information
you stored in the scanner’s working memory,
while resetting all global radio parameters
to factory defaults. V-Scanner memory is not
affected by this operation.
1. Turn off the scanner, then turn it on again.
The scanner briefly displays the DSP boot
version, and then the Welcome/Owner screen
is displayed.
2. Press 0 while the scanner is displaying
the Welcome/Owner screen. The scanner
displays:
System Tests:
Select a Test...
Exits if no key
is pressed
3. Press 2. The scanner displays:
Init GLOB data
To factory state
ENTER if APPROVE
CLEAR to EXIT
To Next Page
Loading...
