Radio Shack PRO-651 - Basic Settings

24
Scanner Setup
25
To set the attenuator mode in the Global Menu:
1. Press PGM for Program Mode.
2. Press GLOB softkey to access GLOB menu.
3. Press p or q to scroll to Atten Mode.
4. Press t or u to select Global or Normal.
5. When attenuator is set to Global, you can set
Global attenuator on or off. Press p or q to
scroll to Global Atten.
6. Press t or u to select on or off.
7. Press SAVE softkey to save the new setting.
To set the attenuator mode using the ATT key:
When the scanner is in Manual Mode, or Program
Mode, Search Mode, or Signal Stalker Mode, or
when it the scan stops:
• Press ATT to toggle on and off the attenuator
setting.
• Press FUNC ATT to toggle on and off the
global attenuator setting.
Basic Settings
The Global menu stores all of the radio-wide
settings used by the scanner. The Global menu
allows you to “tweak” these settings to your
liking. The default settings will work fine for most
users, but you may want to use the Global menu
to personalize the radio to suit your individual
tastes. The most common settings are described
in the following sections. Refer to “Appendix B:
Detailed Menu Reference: GLOB Menu” on page 102
for a description of all the settings.
• The active parameter is always the middle
parameter and is indicated by a flashing colon (:).